Drywall is a big, stiff sheet of finished material that is used to cover the inner walls of houses and businesses. Drywalling is the process of constructing walls without the use of cement or plaster. You’ll need to place drywall along with the studs that frame your home if you want to add or fully renovate a room. Although you may hire a professional to assist you, hanging drywall is a straightforward task that you can complete on your own. To make your room expansion or makeover a success, follow our drywall hanging Denver CO installation guide and discover some suggestions from the specialists.

Materials And Tools For Hanging Drywall

List of tools and materials you need to hang drywall:

  •         Drywall panels
  •         Safety glasses
  •         Dust mask
  •         Drywall square
  •         Utility knife
  •         Drywall knife

How To Hang Drywall

It doesn’t take long to hang drywall, especially if you have help from friends or family. If not, you can always hire a local drywall hanging expert in Denver CO. Learn how to install drywall during your DIY house makeover by following this step-by-step tutorial. 

  1. Measure and cut drywall for the ceiling

Measure out from a corner perpendicular to the strapping or joists. If the panel does not span the full ceiling, its end must rest on a strapping piece or joist in the middle. If it doesn’t, measure from the middle of the panel’s farthest support piece. Transfer that measurement to the first panel’s edge and make a mark. 

  1. Cover the ceiling

Hoist the first panel onto one corner of the ceiling with the help of an assistant. The edges of the strapping or joists should be perpendicular to the wall, and one end should be tight to the wall. Drive five screws in a line across the panel’s width and into the joist or strapping nearest to the panel’s center while the assistant holds the panel.

  1. Using a rotary cut-out tool

Take measurements from the middle of the box to the near end of the last panel installed before laying a sheet of drywall over the electrical box of a ceiling fixture. Make a note of the distance between the panel end and the tape measure. Cover the box with a second panel and attach it as in Step 3; do not drive screws closer than 24 inches to the box. 

  1. Cover the wall

On the adjacent ceiling panels, mark all of the stud placements. Make sure the first panel’s end lands in the middle of a stud with a tape measure; if it doesn’t, cut the panel. Hold the panel against the studs with a helper such that one edge butts against the ceiling panel and the other end snugly against the adjoining wall.

  1. Trim around doors and windows

Install the second row of panels in the same manner as the previous row, butting the edges together closely. (On the bottom row, pry the panel 12 inch up from the floor with a drywall lifter to allow for frame shrinkage.) Offset the end joints from the preceding row by at least 4 feet, just like you did on the ceiling. Hang the panels directly over the bottoms of the window apertures, making sure the seams don’t meet the corners. Do not yet attach the panels to the framework surrounding the apertures. 

  1. Finishing touches

Check for protruding screw heads after all of the drywall has been placed. If you locate any, carefully push them in just below the drywall panel’s surface. Look for screws that were pushed too far into the paper and ripped.

Conclusion

That concludes the discussion. You’re all set to hang some Drywall Hanging and change the look of your room! Slowly work your way into the beat; a little attention now can save you a lot of time and effort later. Make exact measurements and placement of the drywall sheets. The easier it is to finish your project using tape and mud, the nicer and cleaner your hang job is. When you’re ready to go on to the next stage, be sure to hire professional drywall hanging contractors in Denver CO.

At Home Drywall and Painting, our drywall hanging experts offer reliable and affordable drywall repair services in Denver. So, what are you waiting for! Contact us now to book a consultation!

We offer Drywall and Painting Services in the Following Cities

Denver| Minneapolis | Roseville | St Paul | North St Paul | Coon Rapids | Brooklyn Park | Minnetonka | Edina | Woodbury | Lakeville | Eden Prairie | Fridley | Maplewood | Shoreview | Arden Hills | Mounds View | Maple Grove | Shakopee | Chanhassen | Rogers | Plymouth | Golden Valley | Victoria | Champlin | Chaska | Prior Lake | Savage | Hopkins | Andover | St Louis Park | New Brighton | Apple Valley | Burnsville | Ramsey | Anoka | Crystal | Ham Lake | Bloomington | Blaine | New Hope | Richfield | Spring Lake Park | Columbia Heights | Brooklyn Center | Eagan | Little Canada | Mendota Heights | Oakdale | Vadnais Heights | White Bear Lake | Stillwater | Centerville | Falcon Heights | Forest Lake | Gem Lake | Hugo | Lino Lakes | Lauderdale | Mahtomedi | North Oaks | Wyoming | Hudson | Lake Elmo | Grant | Bayport | Newport | Pine Springs | Inver Grove Heights | Rosemount | Orono | St Anthony | Circle Pines | East Bethel | Wayzata | Dellwood | Cottage Grove | Willernie | Pine City | Rush City | Stacy | North Branch | Harris | Cambridge | Braham | Mora | Ogilvie | Grantsburg WI | Siren WI|  Sandstone | Finlayson | Willow River | Moose Lake | Sturgeon Lake | Hinckley | Mission Creek | Rock Creek | Bethel | St Francis | Isanti | Glendale | Edgewater | Lakewood